Programmable Interrupt Controller D8259 from Digital Core Design
[ Back ]   [ More News ]   [ Home ]
Programmable Interrupt Controller D8259 from Digital Core Design

Digital Core Design, IP Core provider and the System on Chip design house from Poland introduced in its offer the D8259. DCD’s Programmable Interrupt Controller is fully compatible with the 82C59A device. As all other cores design by Polish company, the D8259 is technology independent, so it can be implemented both in ASIC and FPGA.

Bytom, 4thof November 2013.The D8259 is a soft Core of Programmable Interrupt Controller, which is fully compatible with the 82C59A device. DCD’s IP core can manage up to 8-vectored priority interrupts for the processor. – But that’s not all, cause you can also program it to cascade and gain up to 64 vectored interrupts  - adds JacekHanke, DCD’s CEO. And if it still seems to be not enough, one can always get more than 64 vectored interrupts, by programming the D8259 to the Poll Command Mode.

The D8259 Package includes fully automated testbench. Thanks to complete set of tests, one can easily validate the whole package at each stage of SoC design flow. Same as all other DCD's IP Cores, this one's got also a technology independent design, that can be implemented in a variety of process technologies.

The D8259 can operate in all 82C59A modes and it supports all 82C59A features:

  • MCS80/85 and 8088/8086 processor modes
  • Fully nested mode and special fully nested mode
  • Special mask mode
  • Buffered mode
  • Pool command mode
  • Cascade mode with master or slave selection
  • Automatic end of interrupt mode
  • Specific and non specific end of interrupt commands
  • Automatic and Specific Rotation
  • Edge and level triggered interrupt input modes
  • Reading of interrupt request register (IIR) and in service register (ISR) through data bus.
  • Writing and reading of interrupt mask register (IMR) through data bus

More information about D8259 IP Core: http://dcd.pl/ipcore/134/d8259/

D8259’s Key Features:

  • 8 vectored priority interrupts
  • Up to sixty-four vectored priority interrupts with cascading
  • Support for all 82C59A modes features
  • MCS-80/85 and 8088/8086 processor modes
  • Fully nested mode and special fully nested mode
  • Special mask mode
  • Buffered mode
  • Pool command mode
  • Cascade mode with master or slave selection
  • Automatic end-of-interrupt mode
  • Specific and non-specific end-of-interrupt commands
  • Automatic and Specific Rotation
  • Edge and level triggered interrupt input modes
  • Reading of interrupt request register (IIR) and in-service register (ISR) through data bus
  • Fully synthesizable HDL Source Code
  • Static design and no internal tri-states

Information about Digital Core Design:

Digital Core Design is a leading Intellectual Property (IP) Core provider and System-on-Chip (SoC) design house. The company was founded in 1999 and since the early beginning has been considered an expert in IP Core architecture improvements. Thousands of customers became convinced by our unique solutions and billions of people worldwide use our technology in USBs, MP3 players, mobile phones and many other applications.

The innovativeness of DCD's IP solutions has been confirmed by over 500 licenses sold to over 300 customers worldwide, such as: INTEL, SIEMENS, PHILIPS, TOYOTA, OSRAM, GENERAL ELECTRIC, SILICON GRAPHICS, RAFAEL, SAGEM or GOODRICH.

More information: http://dcd.pl/page/147/about/ 


Contact: 

Tomeq Cwienk 
Digital Core Design 
ul. Wroclawska 94 
41-902 Bytom
Poland
tel: + 48 32 282 82 66, ext.25
skype: tomasz.cwienk
mail to: Email Contact