voxeljet AG Reports Financial Results for the First Quarter Ended March 31, 2023

In addition, interest expense on lease liabilities amounted to kEUR 292 for the first quarter of 2023, compared to kEUR 36 for the comparative period in 2022. This increase was related to the sale and leaseback transaction regarding voxeljet AG’s properties located in Friedberg, Bavaria, Germany. The transaction closed on October 31, 2022 and the lease term commenced on November 1, 2022. As a result of completion of this transaction, the Company derecognized a carrying amount of kEUR 14,062 relating to land and buildings and recognized a right of use asset and lease liability at an amount of kEUR 9,161 and kEUR 17,263, respectively.

This increase was partially offset by lower interest expense from long term debt, which amounted to kEUR 122 for the first quarter of 2023, compared to kEUR 567 for the first quarter of 2022. This significant decrease was related to the early repayment of the EIB loan in October 2022 as well as further loans which were granted by Sparkasse Schwaben-Bodensee, Germany (formerly Kreissparkasse Augsburg) in August and October 2022. In addition, finance expense related to the change in fair value of bond funds decreased from kEUR 443 for the first quarter of 2022 to kEUR 0 for the first quarter of 2023.

Net loss for the first quarter of 2023 was kEUR 3,251 or EUR 0.35 per share, as compared to net loss of kEUR 753 or EUR 0.10 per share, in the first quarter of 2022.

Business Outlook

Our revenue guidance for the second quarter of 2023 is expected to be in the range of kEUR 4,250 to kEUR 5,750.

We reaffirm our guidance for the full year ending December 31, 2023:

- Full year revenue is expected to be in the range of kEUR 27,500 to kEUR 32,500

- Gross margin for the full year is expected to be above 31.5%

- Operating expenses for the full year are expected as follows: selling and administrative expenses are expected to be in the range of kEUR 14,000 to kEUR 16,000 and R&D expenses are projected to be between approximately kEUR 7,500 and kEUR 8,500. Depreciation and amortization expense is expected to be between kEUR 3,000 and kEUR 3,250.

- Adjusted EBITDA for the fourth quarter of 2023 is expected to be slightly negative to neutral. Adjusted EBITDA is defined as net income (loss), as calculated under IFRS accounting principles before interest (income) expense, provision (benefit) for income taxes, depreciation and amortization, and excluding other operating (income) expense resulting from foreign exchange gains or losses on the intercompany loans granted to the subsidiaries.

- Capital expenditures for the full year are projected to be in the range of kEUR 3,750 to kEUR 4,250, which primarily includes ongoing investments in our subsidiaries.

Our total backlog of 3D printer orders at March 31, 2023 was kEUR 9,249, which represents twelve 3D printers. This compares to a backlog of kEUR 9,975 representing eleven 3D printers, at December 31, 2022. As production and delivery of our printers is generally characterized by lead times ranging between three to nine months, the conversion rate of order backlog into revenue is dependent on the equipping process for the respective 3D printer as well as the timing of customers’ requested deliveries.

At March 31, 2023, we had cash and cash equivalents of kEUR 8,285, additionally we held restricted cash of kEUR 2,986 and held kEUR 3,680 of term deposits, which are included in current and non-current other financial assets on our consolidated statements of financial position.

Webcast and Conference Call Details

The Company will host a conference call and webcast to review the results for the first quarter of 2023 on Friday, May 19, 2023 at 8:30 a.m. Eastern Time. Participants from voxeljet will include its Chief Executive Officer, Dr. Ingo Ederer, and its Chief Financial Officer, Rudolf Franz, who will provide a general business update and respond to investor questions.

Interested parties may access the live audio broadcast by dialing 1-877-704-4453 in the United States/Canada, or 1-201-389-0920 for international, Conference Title “voxeljet AG First Quarter 2023 Financial Results Conference Call”. Investors are requested to access the call at least five minutes before the scheduled start time in order to complete a brief registration. An audio replay will be available approximately two hours after the completion of the call at 1-844-512-2921 or 1-412-317-6671, Replay Conference ID number 13738147. The recording will be available for replay through May 26, 2023.

A live webcast of the call will also be available on the investor relations section of the Company’s website. Please go to the website https://events.q4inc.com/attendee/552705295 at least fifteen minutes prior to the start of the call to register, download and install any necessary audio software. A replay will also be available as a webcast on the investor relations section of the Company’s website.

Non-IFRS Measure

Management regularly uses both IFRS and non-IFRS results and expectations internally to assess its overall performance of the business, making operating decisions, and forecasting and planning for future periods. Management believes that Adjusted EBITDA is a useful financial measure to the Company’s investors as it helps investors better understand and evaluate the projections our management board provides. The Company’s calculation of Adjusted EBITDA may not be comparable to similarly titled financial measures reported by other peer companies. Adjusted EBITDA should not be considered as a substitute to financial measures prepared in accordance with IFRS.

The Company uses Adjusted EBITDA as a supplemental financial measure of its financial performance. Adjusted EBITDA is defined as net income (loss), as calculated under IFRS accounting principles, interest (income) expense, provision (benefit) for income taxes, depreciation and amortization, and excluding other (income) expense resulting from foreign exchange gains or losses on the intercompany loans granted to the subsidiaries. Management believes Adjusted EBITDA to be an important financial measure because it excludes the effects of fluctuating foreign exchange gains or losses on the intercompany loans granted to its subsidiaries. We are unable to reasonably estimate the potential full-year financial impact of foreign currency translation because of volatility in foreign exchange rates. Therefore, we are unable to provide a reconciliation to our forward-looking guidance for non-GAAP Adjusted EBITDA without unreasonable effort as certain information necessary to calculate such measure on an IFRS basis is unavailable, dependent on future events outside of our control and cannot be predicted without unreasonable efforts by the Company.

About voxeljet

voxeljet is a provider of high-speed, large-format 3D printers and on-demand parts services to industrial and commercial customers. The Company’s 3D printers employ a powder binding, additive manufacturing technology to produce parts using various material sets, which consist of particulate materials and proprietary chemical binding agents. The Company provides its 3D printers and on-demand parts services to industrial and commercial customers serving the automotive, aerospace, film and entertainment, art and architecture, engineering and consumer product end markets. For more information, visit http://www.voxeljet.de/en/.

Cautionary Statement on Forward-Looking Statements

This press release contains forward-looking statements concerning our business, operations and financial performance. Any statements that are not of historical facts may be deemed to be forward-looking statements. You can identify these forward-looking statements by words such as ‘‘believes,’’ ‘‘estimates,’’ ‘‘anticipates,’’ ‘‘expects,’’ ‘‘projects,’’ ‘‘plans,’’ ‘‘intends,’’ ‘‘may,’’ ‘‘could,’’ ‘‘might,’’ ‘‘will,’’ ‘‘should,’’ ‘‘aims,’’ or other similar expressions that convey uncertainty of future events or outcomes. Forward-looking statements include statements regarding our intentions, beliefs, assumptions, projections, outlook, analyses or current expectations concerning, among other things, our results of operations, financial condition, business outlook, the industry in which we operate and the trends that may affect the industry or us. Although we believe that we have a reasonable basis for each forward-looking statement contained in this press release, we caution you that forward-looking statements are not guarantees of future performance. All of our forward-looking statements are subject to known and unknown risks, uncertainties and other factors that are in some cases beyond our control and that may cause our actual results to differ materially from our expectations, including those risks identified under the caption “Risk Factors” in the Company’s Annual Report on Form 20-F and in other reports the Company files with the U.S. Securities and Exchange Commission, as well as the risk that our revenues may fall short of the guidance we have provided in this press release. Except as required by law, the Company undertakes no obligation to publicly update any forward-looking statements for any reason after the date of this press release whether as a result of new information, future events or otherwise.

voxeljet AG

« Previous Page 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14 | 15  Next Page »
Featured Video
Editorial
Jobs
Mechanical Engineer 3 for Lam Research at Fremont, California
Manufacturing Test Engineer for Google at Prague, Czechia, Czech Republic
Mechanical Test Engineer, Platforms Infrastructure for Google at Mountain View, California
Equipment Engineer, Raxium for Google at Fremont, California
Mechanical Engineer 2 for Lam Research at Fremont, California
Mechanical Manufacturing Engineering Manager for Google at Sunnyvale, California
Upcoming Events
Celebrate Manufacturing Excellence at Anaheim Convention Center Anaheim CA - Feb 4 - 6, 2025
3DEXPERIENCE World 2025 at George R. Brown Convention Center Houston TX - Feb 23 - 26, 2025
TIMTOS 2025 at Nangang Exhibition Center Hall 1 & 2 (TaiNEX 1 & 2) TWTC Hall Taipei Taiwan - Mar 3 - 8, 2025
Additive Manufacturing Forum 2025 at Estrel Convention Cente Berlin Germany - Mar 17 - 18, 2025



© 2024 Internet Business Systems, Inc.
670 Aberdeen Way, Milpitas, CA 95035
+1 (408) 882-6554 — Contact Us, or visit our other sites:
AECCafe - Architectural Design and Engineering EDACafe - Electronic Design Automation GISCafe - Geographical Information Services TechJobsCafe - Technical Jobs and Resumes ShareCG - Share Computer Graphic (CG) Animation, 3D Art and 3D Models
  Privacy PolicyAdvertise